WS-98X Smart Halo
How to reset my password?
The "Reset" button is located inside the battery compartment of the Smart Halo Panel. When you press the “Reset” button, the password will be reset as “1234”.
Why doesn’t my motion sensor respond to movements sometimes?
The motion sensors are designed as energy friendly with "Sleeping" mode. The "Sleeping" mode will be activated after an event has been identified and will last 3 minutes. And the sensors will be reactivated and ready for detection again after the three minutes.
Why does my motion sensor keep generating false alarms?
The default setting of the motion sensors are with high level of sensitivity. With this mode, the motion sensors will generate alarms when they detect any small movement, such as the movement of your pet. You can adjust to lower level of sensitivity by setting the connector, which is located in the battery compartment.
Is there any certain requirement of this system when connecting with telephones?
This system must be connected to a public switched telephone network with tone frequency at 450Hz+/-20Hz. Please be noted this system does not work with party lines, coin operated phone lines, ISDN connections or any part of a private or corporate switch board system.
How many sensors does the system support?
There is no limit in number of sensors the system is able to support. You can add any number of sensors as necessary to protect you home. When adding new sensors, please make sure that the house security code dipswitch and jumpers of the sensors are set correctly, and instructions can be found in the user manual.
Is the system transferable?
Red Shield Smart Halo System is completely transferable. When you move to a new place, you can move your existing system and sensors to your new property and re-install.
Can I adjust the entry delay and exit delay time?
The factory default setting of entry delay time and exit time is 20 seconds and 30 seconds, respectively. Both can be adjusted between 10 to 60 seconds. Please referred to Page 8 of the user manual for detail instruction on how to adjust the entry/exit time respectively.